Garage Floor Epoxy Flower Mound TX | Installation

Epoxy Flooring Flower Mound: Garage Coatings for Newer Slabs

We handle epoxy flooring in Flower Mound for families who want the garage to work as hard as the rest of the house. Most of the floors we see here are builder slabs: plain gray concrete, a few hairline cracks, and the first oil spots from a daily driver. A garage floor coating from Texas Stone Craft seals that slab, hides the cracks and wipes clean with a damp mop. We install garage floor epoxy and polyaspartic systems across Flower Mound, from Bridlewood to Canyon Falls.

The photo above shows a finished flake floor. Tan, brown and black chips sit in the base coat, and a clear topcoat seals them in. Every system on this page goes down the same way: we grind the slab and fill its cracks first, then lay the coating.

Who Calls Us for a Flower Mound Garage Floor

The typical call comes from a young family in a newer master-planned community. The garage holds two cars, a stroller, bikes, a cooler and the lawn mower. Somebody wants a corner for a squat rack. The floor sheds dust into the house and holds every drip from the car. They want a floor they can hose off.

Plenty of calls start with a failed kit. Somebody rolled a hardware-store epoxy kit on the slab, and within a year it lifted under the tires and peeled near the door. We grind that off and start over.

New-build owners call right after closing, to get the floor coated before the garage fills up.

Epoxy Garage Floor or Polyaspartic: Picking a System in Flower Mound

Both systems bond to ground concrete and both seal it. They differ in how fast they cure, how they handle heat and how they age in sunlight.

Epoxy is a two-part resin. It builds a hard, glossy film that resists oil and household chemicals. An epoxy garage floor in Flower Mound costs less per foot, $3-$5 for basic solid color. The trade-off is time and light. You stay off it for 24-48 hours on foot and 3-7 days with a car, and the film can yellow where afternoon sun lands on it.

Polyaspartic is the system we recommend for most garages. A polyaspartic garage floor in Flower Mound takes foot traffic in 4-6 hours and a car in about 24 hours. It resists hot tire pickup and holds its color under UV. A full polyaspartic flake system runs $6-$9 per square foot.

If the garage gets light use and you can live without it for most of a week, epoxy with a clear topcoat is a fair choice. If you park in it every night, run a workshop in it or need it back by the weekend, go polyaspartic.

Epoxy Floor Installation in Flower Mound, Hour by Hour

A two-car polyaspartic installation takes one working day. This is how that day runs.

Morning: inspection and moisture check. We look for cracks, old coatings, oil-soaked spots and soft concrete. We test moisture coming up through the slab. If it reads above 3 lbs per 1,000 square feet, the floor gets a moisture-mitigating primer.

Grinding. A diamond grinder with a vacuum takes the top skin off the concrete and opens its pores. Acid etching is faster and cheaper, and it bonds worse. A low bid often skips grinding, and etched floors are the ones we see peeling.

Crack and joint repair. We fill cracks with a flexible repair material and grind it flush. Control joints get filled or left open, your call.

Primer and base coat. The primer soaks into the ground surface. The colored base coat goes on next, and we broadcast flake into it by hand while it is wet, edge to edge.

Afternoon: scrape and topcoat. Once the base sets, we scrape off loose flake and roll on a clear polyaspartic topcoat. That coat takes the wear. You can walk on it that evening and park the next day.

Coating a Builder Slab in Its First Few Years

New concrete needs its full 28-day cure before it can take a coating. After that, a newer slab needs little repair and has no old coating to strip.

Builders often spray a curing compound or sealer on fresh slabs. Coatings do not stick to it, so grinding it off is the main job on a newer Flower Mound garage. Skip that and the coating peels in sheets. A floor coated early also never soaks up the oil and tire stains that take extra grinding on an older garage.

What Denton County Clay Does Under a Garage Slab

Flower Mound sits on expansive clay that swells when wet and shrinks in a dry August. A garage slab rides on top of that. Hairline cracks are the normal result, and they show up on new houses too.

That is why the crack repair step matters here. A flexible filler moves a little with the slab instead of popping out. The coating then bridges the filled crack, so the floor looks continuous.

A crack that keeps widening, or one side of a crack sitting higher than the other, points to a slab or foundation problem. A coating will not fix that. If we see those signs during inspection, we tell you before we quote, and you can have it looked at first.

Garage Floor Coating Flower Mound Pricing by Garage Size

Garage floor coating in Flower Mound is priced per square foot. A single bay runs about 250 square feet, a typical two-car garage about 450 and a three-car about 700.

Those prices cover grinding, normal crack repair, primer, base coat, flake or pigment and the clear topcoat. Two things add to them. Removing an old coating adds $1-$2 per square foot. So does a moisture-mitigating primer when the slab tests wet.

To work an example: a 700-square-foot three-car garage with a peeling kit, done in polyaspartic flake, is $4,200-$6,300 for the system plus $700-$1,400 to strip the old kit. That puts the whole job at $4,900-$7,700.

Bigger floors cost less per foot. The trip, the grinder setup and the cleanup cost the same on a 450-foot floor as on a 700-foot one.

Flake Blends, Metallic and Solid Color for Flower Mound Garages

Decorative flake is what most Flower Mound families pick. Vinyl chips are broadcast into the wet base coat until the floor is covered, then sealed under the clear coat. We carry more than 40 blends. Mid-tone mixes of tan, gray and black hide dust, leaves and tire marks between sweeps. The chips also give the surface a light texture that helps with grip.

Metallic uses pearl pigments that swirl as they are worked, so each floor comes out one of a kind. It suits a garage that doubles as a game room, a car display or a finished hangout space. It is glossier and shows dust sooner than flake.

Solid color is one base color under a clear coat. It is the plainest finish and the easiest to clean. It works for a utility bay or a workshop where looks come second.

Not sure which one fits? Upload a photo of your garage to the Epoxy Floor Visualizer and try patterns before the estimate.

Sloped Driveways, Rain and Grit at the Garage Door

Plenty of Flower Mound lots have grade, and many driveways slope down toward the garage. After a storm, water and grit run to the door. Cars carry more in on the tires.

Standing water sits on top of a sealed coating and dries off. Bare concrete soaks it up and stains. The real issue is footing, because a wet gloss topcoat gets slick. We can mix an anti-slip additive into the topcoat for the first few feet inside the door or across the whole floor. Families with small kids or older parents tend to ask for it.

Grit is the other half. Sand and clay dragged in on tires act like sandpaper on any floor. A flake polyaspartic topcoat stands up to it far better than bare concrete or a thin kit, and a weekly sweep keeps it that way.

Summer Heat, Hot Tires and the West-Facing Bay

A car coming off a summer drive in Flower Mound brings hot tires into the garage. Standard epoxy can soften under that heat and the tire can pull it loose when it rolls out. That is the "hot tire pickup" that ruins most hardware-store kits. Polyaspartic is formulated to resist it.

Sunlight is the second test. A garage that faces west or south gets afternoon sun across the front of the floor whenever the door is up. Epoxy yellows under that UV over time. A polyaspartic topcoat holds its color, so the front few feet match the back of the garage years later.

Playrooms, Gyms and Stroller Parking: Family Uses for a Coated Floor

A Flower Mound garage seldom holds only cars. These are the uses we coat for most:

Kids' space. Chalk, scooters, spilled juice and muddy shoes. A flake floor wipes clean and does not shed concrete dust on small hands and knees.

Home gym. Rubber mats on bare concrete trap moisture and smell after a while. A sealed floor under the mats stays dry. Open floor between the mats gets better grip from the flake texture.

Workshop corner. Tool carts roll easier on a coated floor, and spilled stain, oil or solvent wipes up before it soaks in.

Pet area. Dog crates, food bowls and the occasional accident clean up with a mop and a pH-neutral cleaner.

Storage wall. Bins, the second fridge and the holiday boxes sit on a floor that does not wick moisture into cardboard.

Where We Coat Floors in Flower Mound

We take garage floor jobs across Flower Mound, including Bridlewood, Canyon Falls, Wellington, Tour 18 and Stone Creek, plus homes along Long Prairie Road (FM 2499). We also work in nearby Highland Village, Lewisville, Argyle and Grapevine.

Garage size and slab age vary from street to street, so we price each floor on its own measurements. We measure, test and quote at your house. If you live under an HOA, read your covenants before work starts.

Typical Flower Mound Garage Floor Builds

These are typical builds with typical costs, drawn from the prices above.

New-build two-car, polyaspartic flake. About 450 square feet of builder slab with a curing compound on it and a couple of hairline cracks. We grind off the compound, fill the cracks and lay a mid-tone flake polyaspartic system. Typical cost: $2,700-$4,050. One day on site, car back in the next day.

Three-car with a failed kit. About 700 square feet. A DIY epoxy kit lifting under the tires and flaking at the door. We grind the kit off, repair what it hid and lay polyaspartic flake. Typical cost: $4,900-$7,700 including removal.

Single bay turned home gym. About 250 square feet in decorative flake epoxy, with gym mats going back on top once the coating cures. Typical cost at $4-$6 a foot: $1,000-$1,500.

Choosing Among Epoxy Flooring Contractors Near Flower Mound

You will find plenty of epoxy flooring companies near Flower Mound, and their quotes can sit far apart. The gap comes down to prep and topcoat. Ask every bidder these questions:

• Do you diamond-grind the whole floor, or etch it?
• Do you test the slab for moisture?
• How do you repair cracks?
• Is the topcoat polyaspartic or epoxy?
• How long until I can park?
• What does your warranty cover, and for how long?

Good epoxy floor installers in Flower Mound answer all six without hedging. Our answers: we grind every floor, test moisture, fill cracks with flexible repair material, topcoat in polyaspartic unless you choose epoxy, and back the work with a 5-year workmanship warranty.

Care, Warranty and the 15-Year Refresh

Every floor we coat carries a 5-year workmanship warranty, in writing. If the coating fails because of our prep or install, we return and repair it.

Care takes a few minutes a week. Sweep or blow out the garage weekly. Mop as needed with a pH-neutral cleaner. Skip harsh degreasers and acid cleaners, which dull the clear coat. Wipe oil and chemical spills when you see them. The sealed surface keeps them from soaking in.

A polyaspartic floor goes 15-20 years before the clear coat wears enough to need attention. The refresh is a light sanding and a new topcoat, done in a day. There is no full strip unless the floor has been damaged.

What a Coated Floor Adds When You Sell

Buyers open the garage on a showing. When they see a stained gray slab, they add one more job to their list.

We make no promise about sale price. A sealed floor that gets swept and mopped looks on listing day much as it did after install, with no oil shadows and no peeling kit to explain.

Next Steps for a Flower Mound Garage Floor

Send us your garage size and a couple of photos through the contact form. We will set a time to inspect the slab, test it, and give you a fixed price for each system that fits.

• Polyaspartic vs Epoxy: Full Comparison
• Same-Day Polyaspartic Garage Case Study
• How Polyaspartic and Epoxy Compare in Frisco Garages
• Epoxy Flooring DFW Hub
• Get a Free Flower Mound Garage Floor Estimate

More Services in Flower Mound

• Retaining Walls Flower Mound
• Water Features Flower Mound

Explore Other DFW Epoxy Service Areas

• Epoxy Flooring Dallas
• Epoxy Flooring Fort Worth
• Epoxy Flooring Plano
• Epoxy Flooring Frisco
• Garage Floor Coatings Keller

Related Services

• Concrete Overlays
• Stamped Concrete

Last updated: November 2026